Commercial Swing Gate Operator with two 1/2 HP motors. One motor opens the gate, the other closes it.

Commercial Swing Gate Operator with two 1/2 hp motors. One motor opens the gate, the other closes it. The CSW-200-UL-DM™ uses a unique, patented, dual motor feature. One motor opens the gate and the other one closes it, unlike any other operator in the world. Because of this feature the operator can function in less than ideal conditions, such as desert environments, and not overheat the motors. The CSW-200-UL-DM™ is specified for use at heavily accessed high traffic areas such as multiple family communities with 250 or more homes in high ambient temperature applications.

Electrical Specifications:

Alarm:  If the gate hits a vehicle while closing it re-opens. If it hits a vehicle while opening it stops, reverses 4 to 6 inches and stops again
Alternate Outputs:  With Omni Option board, three push button command control, buglar alarm input and output
Burglar Alarm:  With Omni Option board, interfaces with existing home alarm or alarm output
Digital Motor Protection:  Entrapment sensor shuts off the motor after it reaches the stall amp for 3 seconds, reverses direction for several inches and stops
Electronic Inputs:  Radio receiver, key switch, safety loop, center loop, telephone entry system, computer input, fire department key switch, and 3-push-button station
ERD Sensor:  If the gate hits a vehicle while closing it re-opens. If it hits a vehicle while opening it stops, reverses 4 to 6 inches and stops again
Gate Traveling Time:  Adjusted by a precision mechanical device and electrical limit switch system.
Integrated Loop Detectors:  Easy to install, modular, plug in loop detector inputs for exit loop, center loop, and safety loop
Intelligent Master/Second:  Precise, synchronized movement and communication between two gate operators using three wire RS-485 bi-directional technology
Magnetic Lock:  With Omni Option board, magnetic lock system is incorporated, allowing easy addition of the MG1300 locking system to the gate
Modular Board:  Uses LEDs to indicate all input and output functions of the gate operator
Motor Drive:  Solid state electronic motor drive system is incorporated into the board
Power Input Controls power input to the board with convenient switch
Power Management:  Board includes electronic power management with over curent shutdown and automatic recovery
Soft Stop:  Gate travels through the cycle at normal speed and comes to a stop slowly for more accurate gate cycle. Equipped with integrated time delay for long mechanical life expectancy
Spike Suppressors: Fast response time (50 nanoseconds) when subject to an impulse surge (lightning strike) up to 100 amps
Three Push Button Control:  On board gate operator control for close, stop and open.
Timer:  Adjustable timer can be set from 0-60 seconds

Mechanical Specifications:

Approval:  UL and ETL listed to the latest UL325 and UL991 specifications
Chassis:  Constructed with .25 inch sanded, welded, and gold zinc plated sheet metal
Cover:  High density polyethylene plastic and stainless steel for excellent heat and corrosion resistance
Dimensions:  Length = 24.5in x Width = 15in x Height = 285in
Emergency Release:  Can be easily disconnected ty turning the emergency handle 180°. The best option is our DC-1000
Finish:  All metal parts are gold zinc plated for rust proof protection
Gate Length:  18 feet maximum gate length
Motor:  Equipped with two 4.7 AMP, 115VAC, 1/2hp instant reversing motors. One motor opens the gate, the other closes it
Output Shaft:  2.5 inch cold rolled steel
Swing Arm:  Non-scissor type arm action
Travel Speed:  90° opening in 13-15 seconds
Weight Capacity:  800 pounds maximum gate weight
Worm Gear Reduction:  Two, 30-to-1 worm gears equal a 900-to-1 reduction. Both are lubricated in an oil bath